Wika DPT-10 User Manual download pdf (Page 45)

6.4 Parameter description

DPT10 has general adjustment parameters which are also used for

other measuring principles as well as instrument-speciﬁc adjustment

parameters. The general adjustment parameters are described in the

operating instructions manual "Indicating and adjustment module".

The instrument-speciﬁc adjustment parameters are described in this

chapter.

Information:

If the adjustment limits of the adjustment parameters are exceeded,

the message "Outside parameter limits" appears. The editing

procedure can be aborted with [ESC] or the displayed limit value can

be accepted with [OK].

DPT10 can be used for diﬀerential pressure, level as well as ﬂow

measurement. The delivery status is level measurement. The selection

is made in the menu item "Application". Depending on the selected

application, the adjustment is carried out as zero/span or min./max.

adjustment.

Proceed as follows to switch over to the application diﬀerential

pressure or ﬂow measurement:

1 Push the [OK] button in the measured value display, the menu

overview is displayed.

▶

Basic adjustment

Display

Diagnostics

Service

Info

2 Conﬁrm the menu "Basic adjustment" with [OK].

Application

Level

▼

3 Conﬁrm the menu item "Application" with [OK].

Warning:

Note the warning: "Output can change".

4 Select with [->] "OK" and conﬁrm with [OK].

5 Select the requested application in the selection list, for example

"Flow" and conﬁrm with [OK].

Introduction

Application

Diﬀerential pressure transmitter DPT10 - metal measuring diaphragm • Proﬁbus PA 45

6 Adjustment with the indicating and adjustment module

37245-EN-100120

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 95 96

No comments

Wika DPT-10 User Manual Page 45