Wika Pascal ET User Manual download pdf (Page 63)

6 Commissioning, operation

WIKA Operating Instruction, Model Pascal ET and Pascal ET/IS 63

4) 2 CH To show 2 channels on the dispaly, as per picture below.

Figure 68 – Two channels display

5) 4 CH To visualize all the 4 Channels on the display.

6) 24V OUT To power on /off the 24 Vcc to supply the power to the device under test

6.4.3 Report Menu

This menu enables to access to the calibration reports and calibration procedures section.

For more information please refer to Chapter 6.7

6.4.4 Engineering unit Menu

Engineering unit displayed can be changed faster selecting and pressing the box ENG.UNIT on the

active menu: this is possible only for channels assigned for pressure or temperature

measurements.

6.4.5 Logger Menu

Selecting the box LOGGER the following menu is accessed: SETUP, VIEW. LOG, DEL.LOGS

For more information please refer to Chapter 6.8.

6.4.6 Calibration Menu

The calibration menu allows the calibration of the parameters available on the calibrator.

Separate Operating instruction available.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 87 88

No comments

Wika Pascal ET User Manual Page 63