Wika CTH6300 User Manual download pdf (Page 13)

13WIKA operating instructions, models CTH6300 and CTH6500

2079988.04 07/2014 GB/D

4. Design and function

5) Function keys

Conguration of the instrument

6) ON/OFF button

Turning the instrument on and o

7) ESC key

Back to measuring mode

4.4 Voltage supply

The BAT segment indicates that the battery must be replaced soon. At this point correct

measurements can be performed for approx. 1 hour.

A 9 V battery is used as voltage supply of the instrument.

Replacing batteries

For battery replacement switch o the instrument and open the battery compartment

attached on the rear side. After that remove the battery and disconnect the connection

cable. Then insert the new batteries into the battery compartment.

Switch in the battery compartment on the rear side allows to specify whether the

instrument is operated with a battery or a rechargeable battery.

With the setting Batt the charging current supplied via USB interface is not directed to

the battery, which allows to avoid its damage.

With the setting Accu the rechargeable battery is only energized via USB interface. The

accu will be provided with charge current, but this is not enough the recharge the accu

completely.

If the instrument is not used for a long time, remove the battery.

When closing the battery compartment make sure that the battery

connection wires are not jammed or damaged.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 79 80

No comments

Wika CTH6300 User Manual Page 13